​

The tools you will need are as follows:

​​

• A RoboSapien (duh)

• Hot glue gun (I recommend surebond brand)

• Wire jackets or shrink wrap

• 2 spools of flux/rosin core solder

• soldering iron

• Dremel

• super glue

• narrow long Phillips head screwdriver

• smaller screwdrivers

• Velcro and fabric for the fabric neck

• coat hanger wire

• needle nose pliers

• wire tools (clippers, heat shrink, electrical tape and jacket removers)

​

Once you have ensured that you have everything listed above, you need to order the items in the amazon list below.

​​

Computer (Raspberry Pi 02W)

Pi Header Tool (If needed)

ToF sensor for basic navigation

For Super Pysapien: (Not required) Coral TPU

OTG cord for linking TPU

Camera Module

Batteries and charger board

Battery Connects (Optional)

Face Screen (Must be IIC)

Speaker

Bluetooth Circuit

Motor Drivers (You 4 of them)

Positive Contact Foot Relay

INA 219 (You must remove the shunt)

Camera Extension

​Servos (head/claws)

Barrel Connector

GPIO expander

Cooling fan

High gauge wire (For battery connects)

Low gauge jumper wire (For computer and everything else)

Toggle Switch (used for deep cycle and power)

​

 

 

And you can pick up these parts from your local supermarket:

​

Good, cheap SD Card (200 GB recommended for later AI updates)

Car Charger (good way to get a cheap high amperage buck converter)

​Some metal tape for the battery contacts

​

​It should cost anywhere from 150 bucks to 200 bucks.

You can probably build 2 PySapiens with most of these items, bulk is the only option for fast shipping. If you have the experience and time, I would recommend using alibaba or some other cheap e commerce platform.

​

​

​​

As there is no official guide yet, the list ends here.

I am however, working on the build guide right now.

feel free to attempt to build the robot as you see fit for the time being.

​

​

​

​